Support / FAQs / About techtown

Home Forums Archives i have a true GDm-49 2 door frig.  It it not holding temp and actually going to 10F and below.  I replaced the thermostat, but still freezing.  Any suggestions for a possible fix.  thank you!

  • i have a true GDm-49 2 door frig.  It it not holding temp and actually going to 10F and below.  I replaced the thermostat, but still freezing.  Any suggestions for a possible fix.  thank you!

     fixbear updated 1 year, 3 months ago 1 Member · 3 Posts
  • guest

    Member
    November 19, 2018 at 12:00 am

    True refrigerator not holding temp and actually going down to zero and below.  thermostat just replaced and did not fix.  any suggestions?

  • fixbear

    Member
    November 19, 2018 at 7:58 pm

    First question, is the product actually freezing HARD? Or is it just a fault with a temperature indicating device.   Does your machine have a digital controller?   For it to get the box that cold would require the compressor to run continuosly.  So you either have a thermostat problem or a miss wire to the compressor.

  • fixbear

    Member
    November 20, 2018 at 4:50 pm

    I haven’t heard back from you on this, so I would like to add that you should check the thermistor and the fan motors. If you have a bad bearing on a evaporator fan motor it will sometimes set up and not circulate. Freezing the coil. And giving a low temp reading.

Log in to reply.

Original Post
0 of 0 posts June 2018
Now